Daybreak 1304 조립 지침 - 페이지 2

{카테고리_이름} Daybreak 1304에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Daybreak 1304 2 페이지. Rollback glider

STEP 2

Chair Assembly

a. Locate Seat (2), Back (1), Right Arm (3) and Left Arm (4) assemblies.

b. Lay seat on the side and use 2pcs. 3" Carriage Bolts (D) to fasten the front legs to the seat (use a soft mallet

to pound the carriage bolts in). They should lay flat against the back of the head of carriage bolt.

c. Use 2pcs 4" Bolts (C) to fasten the back leg, seat and back together in a sandwich assembly - use Flange

Nuts (H) to tighten.

d. Line the hole in the side of the arm with the hole in the back side to fasten. Use 3" Bolts (D) and Flange

Nut (H) to fasten.

e. Repeat for the other side of chair.

H H

STEP 3

Mounting Chair to Glider Base

a. Lay the chair on the side and use 4pcs. 2 3/4" Carriage Bolts (B) in the bottom hole on each leg - The bolt

head should be to the outside of chair and bolt sticking out on inside (use a soft mallet to pound the

carriage bolts in). They should lay flat against the back of the head of carriage bolt.

b. Use 4pcs. 3/8" Flange Nuts (F) on the inside of leg to tighten Bolt before moving on to mounting the Glider Arms (A).

c. Mount the 4pcs. Glider Arms (A) to the legs - use 3/8" Lock Nuts (G) to fasten the glider arms to the legs of the chair.

d. Place the other end of the glider arms on to the glider base and fasten using 4pcs. 3/8" Lock Nuts (G) (Be

careful to not allow it to swing and pinch your fingers!)

C C

Questions in regards to your product email [email protected]

Page 2/2