Gaggenau VL 430 작동 및 조립 지침 매뉴얼 - 페이지 12

{카테고리_이름} Gaggenau VL 430에 대한 작동 및 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau VL 430 16 페이지. Hob ventilator

• Turn the clamping screws to the side. Insert the

appliance with the control panel on the front into

the cut-out and align it.

Note: do not stick the appliance onto the worktop

with silicone.

• Turn the clamping screws under the countertop

and tighten them evenly. Do not tighten the

clamping screws too tightly, as a uniform sealing

gap should be left all round.

• Connect the appliance to the fan module by

means of a flexible aluminium pipe with a

diameter of 125 mm.

• Connect the appliance to the fan module by

means of the 4-pole plug.

We recommend the use of our telescopic wall box

TM 180-043 to route exhaust air through the outside

wall.

Installing the edge trim AL 400-000

The edge trim has to be fitted to the side of the hob

ventilator, if this ventilator is installed together with

other Vario appliances and forms the left or right

edge of this combination.

The edge trim does not change the total width of

the cut-out, however, the width of the edge trim has

to be added to the total width of the appliance

combination.

Simply press the edge trim under that side of the

ventilator, that forms the edge of the combination.

The hooks on the side of the edge trim will latch

into the openings provided on the hob ventilator.