Gaggenau CK 270 작동 및 조립 지침 매뉴얼 - 페이지 10

{카테고리_이름} Gaggenau CK 270에 대한 작동 및 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gaggenau CK 270 12 페이지. Glass-ceramic hob with superquick cooking zones

페이지 인쇄

6. Assembly instructions

6.1 Technical data

Appliance dimensions: L 700 x T 510 x H 63,5 mm

Installation dimensions: L 680 x T x 490 x H 55 mm

Total rating: 7.2 kW

6.2 Important notes on installation

– Pay attention to the "Important notes"

(Chapter 1).

– The appliance must only be connected by an

authorised specialist, paying attention to the

relevant regulations of the power supply compa-

nies and the regional construction regulations.

– The electrician is responsible for the correct

functioning of the appliance at the time of

installation. He must instruct the user on how

to operate the appliance correctly on the basis

of the Operating Instructions, and the user must

be instructed on how to disconnect the appliance

in an emergency.

– If the range is not installed over a built-in cooker,

protection against hazardous contact from

below must be ensured after assembly, e.g. by

installing an intermediate shelf that can only be

detached using a tool.

The distance between the intermediate shelf and

the worktop in which the range is recessed must

be at least 60 mm.

– Note: when installing a shelf, observe a distance

of at least 50 mm from the bottom edge of the

housing trough to the shelf or the next

combustible item of furnishing.

– If all poles of the appliances cannot be isolated

from the mains by removing an accessible plug

(of a permanent connecting lead), an isolating

device with a contact gap of at least 3 mm must

be installed (e.g. domestic fuse).

– No warranty claims can be lodged for any

damage resulting from failure to observe

these instructions.

– When the appliance is installed in a base cabi-

net with a width of less than 60 cm, the housing

can lie on the side walls of the cabinet. These

cabinet side panels must be modified so that the

appliance is not in contact with them.

Note: Please note that a distance of 10 mm from

the base cabinet must be observed for safety

reasons.

– The distance from the lower edge of the housing

trough to the next combustible item of furnishing

at the side should be at least 20 mm.

– Note: Do not stick the cooking surface onto the

worktop with silicone !

– Electrical connection

Rated power consumption: 7.2 kW

The appliance must only be connected by an

authorised specialist.

All corresponding regulations must be observed.

– The mains connecting cable must at least

correspond to the type H 05 VV-F .

– Pay attention to the data on the rating plate

and connect the PE conductor. Connect the

connecting cable to the mains. The appliance can

be connected with a plug or it can be connected

permanently.

– When connecting electrical appliances and

devices in the proximity of cooking surfaces and

ovens, make sure that connecting cables do not

become jammed under the hot oven door or

come into contact with hot cooking surfaces.

– This cooker corresponds to heat class Y and

must be installed in a cabinet as detailed in the

sketch (Fig. 7).

– This appliance may be installed in kitchen com-

binations made of wood or similar combustible

materials without taking additional measures.

CK 270-504

AC 240 V

CK 270-104

AC 230/400 V

FD xxxx

50/60 Hz

7200 W

FD xxxx

3 N / 50/60 Hz

7200 W

3 x 16 A

30 A