GREAT PLAINS 1205NT 현장 조정 매뉴얼 - 페이지 5

{카테고리_이름} GREAT PLAINS 1205NT에 대한 현장 조정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLAINS 1205NT 5 페이지. End wheel no-till drill
GREAT PLAINS 1205NT에 대해서도 마찬가지입니다: 사전 제공 매뉴얼 (20 페이지)

페이지 인쇄

Feed Cup Adjustment:

Each feed cup is equipped with a four-position adjust-

ment handle.

A) The highest position is for wheat and other small

grains

B) The second is for soybeans and other large grains

C) The third is used if the seeds are cracking in the

second position

D) The bottom position is for clean out and will drain all

seed

Note: Do not open the seed cup handle to the bottom

position with seed in the box unless complete clean

out is desired. Changing this handle will change the

seeding rate. When storing after drilling season, it is

best to place the handle in the bottom position to pre-

vent damage from mice.

Select Drive Type:

The gearbox is designed to give a variety of drive

speeds for different types of seeds and rates. It is a lin-

ear shift pattern design with constant mesh gearing

and is totally sealed to keep any dirt out. No lubrication

is required unless service is needed.

1) To set the gearbox, move the selector handle until

the desired drive type appears in the window on the

handle.

48509

Main Seed Box Drive Type Ratios

Drive Type 2 is 2.06 Times Faster Than 1

Drive Type 3 is 3.08 Times Faster Than 1

Drive Type 4 is 5.03 times Faster Than 1

5 of 5

Document

#DRUS500C-0002A