Agriframes 40136 조립 지침 - 페이지 3

{카테고리_이름} Agriframes 40136에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Agriframes 40136 4 페이지. 6ft classic extra monet arch

Site preparation

3.1. Place the roof structure in the site that you intend to install

the arch and mark the positions of the four uprights.

Remove the roof section and use the Holemaker to make

15" deep holes at each of the marks. Ensure that the holes

are all vertical and the same depth.

3.2. Place one of the uprights in each hole and ensure that the

tops are level. Adjust if necessary.

Final assembly

4.1. Slide two of the remaining spacer bar assemblies onto

each pair of uprights. Attach the first 14" above the

ground and the second 50" higher.

4.2. Slide a moisture seal onto the top of each upright and lift

the roof section onto the uprights. Once it is attached

securely slide the moisture seals up to cover the tube

joins.

4.3. Place a third screw in each T joint. Check that all the

measurements are correct and then fully tighten all joints

and screws.

4.4. If you purchased the lattice infill it can be attached to the

structure, between the horizontal spacers, using the ties

provided.

PACKING REFERENCE: