GREAT PLAINS 3P1006NT 현장 조정 매뉴얼 - 페이지 2

{카테고리_이름} GREAT PLAINS 3P1006NT에 대한 현장 조정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLAINS 3P1006NT 4 페이지. 3-point eight & ten foot no-till drills

페이지 인쇄

Adjusting Coulter Height:

Raising the gauge wheel spindle provides deeper

coulter depth while lowering the gauge wheel provides

shallower depth.

Note: Do not lower the coulters to aid

in penetrating hard soil. Instead, increase coulter

down-force or add optional weight to the drill.

1) Determine the desired coulter depth. With new

coulter blades, the axle holes provide the following

depths:

Hole No.

(from top)

2) Raise the drill until the spindle can be adjusted any

distance.

3) Loosen the chain idlers.

4) Remove the wheel bolts and move the spindle to the

desired hole. Re-install the wheel bolts.

5) Re-engage the chains idlers and check the overall

depth.

Individual Coulter Height Adjustment:

Individual coulter depth may be adjusted by raising and

lowering the spring bar.

1) Determine the new desired coulter depth, and/or the

difference between that and the current depth.

2) Raise the drill until the coulters are just touching the

ground. The press wheels are supporting some weight

at this point.

3) Measure the current spring bar length, from the bot-

tom of the tool bar to the bottom of the spring bar. For

reference, the factory setting is roughly 12 1/2 inches

(31.8 mm).

4) Determine the new bar length required and loosen

the clamp bolts (1).

5) Use a mallet to adjust the bar height and re-tighten

the clamp bolts (1) once the desired height is achieved.

Document

#DRUS100C-0003A

Coulter Depth

Inches

3 1/2 in.

89 mm

2 7/8 in.

73 mm

2 3/8 in.

60 mm

1 7/8 in.

48 mm

1 3/8 in.

35 mm

7/8 in.

22 mm

3/8 in.

10 mm

1/4 in.

6 mm

48874

48875

2 of 4