GREAT PLAINS 3P806NT 현장 조정 매뉴얼 - 페이지 4

{카테고리_이름} GREAT PLAINS 3P806NT에 대한 현장 조정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLAINS 3P806NT 4 페이지. 3-point eight & ten foot no-till drills

T-Handle Adjustment:

The depth of each opener is controlled by the height of

the press wheel. Varying the height of the press wheel

changes the seeding depth of the opener. Moving the

"T" handle to the front of the opener shallows the

depth; moving the "T" handle towards the rear of the

opener increase the depth. For a starting point, place

the "T" handle towards the center.

Feed Cup Adjustment:

Each feed cup is equipped with a four-position adjust-

ment handle:

A) The highest position is for wheat and other small

grains

B) The second position is for soybeans and other large

grains

C) The third position is used if the seeds are cracking

in the second position

D) The bottom position is for clean out and will drain all

seed

Note: Do not open the feed cup handle to the bottom

position with seed in the box unless complete clean out

is desired. Changing this handle will change the seed-

ing rate. When storing after drilling season, it is best to

place the handle in the bottom position to prevent dam-

age from mice.

Selecting Drive Type:

The gearbox is designed to give a variety of drive

speeds for different types of seed and rates. It is a lin-

ear shaft pattern design with constant mesh gearing

and is totally sealed to keep any dirt out. No lubrication

is required unless service is needed.

1) To set the gearbox, simply move the selector handle

until the desired drive type appears in the window on

the handle:

Main Seed Box Drive Type Ratios

Drive Type 2 is 2.06 Times Faster Than 1

Drive Type 3 is 3.08 Times Faster Than 1

Drive Type 4 is 5.03 Times Faster Than 1

Document

#DRUS100C-0003A

48642

48509

48877

4 of 4