Dynabrade 52715 안전, 운영 및 유지보수

{카테고리_이름} Dynabrade 52715에 대한 안전, 운영 및 유지보수을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynabrade 52715 8 페이지. 1hp cone or plug grinder governor controlled

페이지 인쇄

1Hp Cone or Plug Grinder

Governor Controlled

Models:

52715 – 12,000 RPM

52716 – 15,000 RPM

52717 – 18,000 RPM

52718 – 20,000 RPM

Carefully Read all instructions before operating or servicing any Dynabrade

Products offered by Dynabrade are not to be modified, converted or otherwise altered from the original design without expressed written consent from Dynabrade, Inc.

Tool Intent:

Cone or Plug Grinders are ideal for smoothing weld seams, cleaning castings and preparing surfaces for plating or painting.

Training:

Proper care, maintenance, and storage of your tool will maximize its performance.

• Employer's Responsibility – Provide cone or plug grinder operators with safety instructions and training for safe use of tools and accessories.

Accessory Selection:

• Abrasive/accessory RPM (speed) rating MUST be approved for AT LEAST the tool RPM rating.

• Before mounting an accessory, visually inspect for defects. Do not use defective accessories.

• Mount only recommended accessories. See back page of manual and Dynabrade catalog.

• Follow tool specifications before choosing size and type of accessory.

• Only use recommended fittings and air line sizes. Air supply hoses and air hose assemblies must have a minimum working pressure rating of 150 PSIG (10 bars, g) or 150

percent of the maximum pressure produced in the system, whichever is higher. (See tool Machine Specifications table.)

• DO NOT use – cut off wheels or router bits.

Warning:

Always wear eye protection. Operator of tool is responsible for following: accepted eye, face, respiratory, hearing and body protection.

WARNING

SAFETY LEGEND

WARNING

SAFETY INSTRUCTIONS

Do Not Use Tool For Anything Other Than Its Intended Applications.

OPERATING INSTRUCTIONS

(Continued on next page.)

Abrasive Power Tool.

WARNING