GREAT PLAINS 606NT 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} GREAT PLAINS 606NT에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLAINS 606NT 6 페이지. Six foot no-till drills
GREAT PLAINS 606NT에 대해서도 마찬가지입니다: 유지 관리 매뉴얼 (7 페이지)

페이지 인쇄

Leveling The Drill 606NT:

1) The drill must be lowered until weight is taken off of the

hitch turnbuckle. Do not attempt to adjust the turnbuckle with

the drill risen.

2) Loosen the jam nuts on the hitch turnbuckle (1).

3) Shorten or lengthen the turnbuckle until the top of the drill

frame is parallel to the ground.

the clevises beyond the turnbuckle.

4) Once the drill is level, re-tighten the jam nuts.

Adjusting 3-Point Height 3P606NT:

Raising the gauge wheel spindle provides deeper coulter

depth while lowering the gauge wheel provides shallower

depth.

Note: Do not lower the coulters to aid in penetrating

hard soil. Instead, increase coulter down-force or add optional

weight to the drill.

1) Determine the desired coulter depth. With new coulter

blades, the axle holes provide the following depths:

Hole No.

(from top)

2) Raise the drill until the spindle can be adjusted any distance.

3) Loosen the chain idlers.

4) Remove the wheel bolts and move the spindle to the desired

hole. Re-install the wheel bolts.

5) Re-engage the chain idlers and check the overall depth.

Individual Coulter Height Adjustment:

Individual coulter depth may be adjusted by raising and lower

the spring bar.

1) Determine the new desired coulter depth, and/or the differ-

ence between that and the current depth.

2) Raise the drill until the coulters are just touching the ground.

The press wheels are supporting some weight at this point.

3) Measure the current spring bar length, from the bottom of

the tool bar to the bottom of the spring bar. For reference, the

factory setting is roughly 12 1/2 inches (31.8 mm).

Note: Be careful not to extend

Coulter Depth

Inches

3 1/2 in.

89 mm

2 7/8 in.

73 mm

2 3/8 in.

60 mm

1 7/8 in.

48 mm

1 3/8 in.

35 mm

7/8 in.

22 mm

3/8 in.

10mm

1/4 in.

6 mm

48743

48744

3 of 6

Document

#DRUS500C-0003A