GREAT PLAINS 706NT 사용 설명서 - 페이지 6

{카테고리_이름} GREAT PLAINS 706NT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLAINS 706NT 6 페이지. End wheel no-till

2.) SPRING TENSION ON THE OPENERS: The "W" clips on the opener spring rods

should be in the lowest hole. This is the correct location in all conditions. The "W"

clips can be raised one hole in the wheel tracks only if penetration is not adequate.

3.) SEED DEPTH: All opener "T" handles should be set the same (about

mid range) when starting. Check seed depth by digging down to the seed, adjust

to desired depth by moving the "T" handle. It may be desirable to put the T-

handles in the rows behind the wheel tracks, one hole deeper to maintain proper seed

depth.

1.) COIL TINE HARROW: A coil tine harrow is available as optional equipment that

will pull residue over the seed and help in reducing soil crusting. Adjust the harrow

for no-till by raising the front bar to run 1 inch to 1½ inches higher than the rear

bar. The front set of teeth should be set to run flatter than the rear bar.

OPTIONS