Hi-Tech 22-225 사용 설명서 - 페이지 11

{카테고리_이름} Hi-Tech 22-225에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Tech 22-225 16 페이지.

SAW BLADE ADJUSTMENTS

BLADE POSITIONING &

CLEARANCE ADJUSTMENTS

Follow these four steps to adjust the position of

the saw arbor and saw blade so that the blade

does not make contact with the saw table.

Carefully remove the saw table and loosen the

two set screws located in the saw arbor using

the Allen wrench, turning counter-clockwise (Fig.

G). Once loosened, the saw arbor can slide side

to side.

Replace the saw table and position the saw

blade so that it is not in contact with the saw

table. Your blade should spin freely.

Manually rotate the saw blade until you see

one set screw exposed under the saw table

(Fig. H). Tighten this exposed set screw using the

Allen wrench, turning clockwise. Carefully remove

the saw table to tighten the other set screw. Both

set screws at this point should be tightened.

Replace the saw table and manually rotate

the saw blade, making sure the blade is

not making contact with the saw table, before

turning the trim saw on.

NEED A REPLACEMENT SET SCREW?

The two set screws located in the saw arbor are available at your local hardware store. The size of the

set screws are 18-8 stainless steel, cup point, 10-32 thread, 3/16" long.

Fig. G

Fig. H