Hi-Tech Diamond Slant Cabber Glass/Crystal 사용 설명서 - 페이지 9

{카테고리_이름} Hi-Tech Diamond Slant Cabber Glass/Crystal에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Tech Diamond Slant Cabber Glass/Crystal 16 페이지.

GRINDING AND POLISHING

still see scratches or scales, they are too deep to

remove. You must return to step 1 (360# disc) and

start this process over. If after this step, your piece

has a finely frosted finish, then you are ready to

move onto step 4.

STEP 4: PRE-POLISHING

The 3,000# diamond disc removes the satin-like

finish from the previous step. Install the 3,000#

disc according to the instructions on page 7. Your

goal after this step is a very smooth, hazy surface.

There should be no visible scratches or scales at

3,000# diamond disc

this point. If you can still see scratches, you need

to go back to step 1. This disc preps your piece for

the final polish.

STEP 5: POLISHING

The Tech-10 polishing pad is used to put the final

polish on your material. You will need to charge

the Tech-10 polishing pad with the 14,000#

diamond paste before use. To do this, take the

diamond paste syringe, remove the cap and

squeeze the syringe plunger in a series of small

dots onto the surface of the Tech-10 pad (Fig.

C). Use your fingers to rub these small dots into

Tech-10 polishing pad with

the pad. Once charged, you will only need to

14,000# diamond paste syringe

apply additional diamond paste to the pad when

you notice that the pad is no longer polishing.

Using the Tech-10 polishing pad with water is

not required because the diamond compound

mixture contains its own carriers. However, if you

are working with brittle, heat sensitive material,

such as opal, be careful not to let your work

piece overheat. To avoid overheating, use a very

small amount of clean water to keep your work

piece cool or simply lower the RPM to reduce

heat buildup. Note: Use only one type of polishing

compound per Tech-10 polishing pad. Do not mix.

Fig. C