Dynabrade 13531 안전, 운영 및 유지보수 - 페이지 2

{카테고리_이름} Dynabrade 13531에 대한 안전, 운영 및 유지보수을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynabrade 13531 9 페이지. 1 hp dynastraight 6" extension, governor controlled, 1,800/3,400/4,500/6,000 rpm with 5/8" or 1" combination arbor/with 1/2" diameter arbor, with 5/8"-11 threaded arbor

페이지 인쇄

Warning: Always wear eye protection. Operator of tool is responsible for following: accepted eye, face, respiratory, hearing and body protection.

Caution: Hand, wrist and arm injury may result from repetitive work, motion and overexposure to vibration.

• Keep hand and clothing away from working end of the air tool.

Operation: Be sure that any loose clothing, hair and all jewelry is properly restrained.

• Secure inlet bushing on air tool with a wrench before attempting to install the air fitting to avoid damaging housing assembly.

• Check tool RPM (speed) with tachometer with air pressure set at 90 PSIG while the tool is running. If tool is operating at a higher speed than the RPM

marked on the tool housing, or operating improperly, the tool must be serviced and corrected before use.

Caution: Tool RPM must never exceed abrasive/accessory RPM rating. Check accessory manufacturer for details on maximum operating speed or special

mounting instructions.

• With power source disconnected from air tool, mount recommended accessory onto arbor assembly.

• When mounting abrasive or accessory on arbor be sure to follow recommended procedure of the manufacturer.

• Connect air tool to power source. Be careful NOT to depress throttle lever in the process.

Do not expose air tool to inlet pressure above 90 PSIG or (6.2 Bars).

Caution: After installing the accessory, the Extension Dynastraight must be started at a reduced speed to check for good balance. Gradually increase tool

speed. DO NOT USE if tool vibration is excessive. Correct cause, and retest to insure safe operation.

• Make sure that work area is uncluttered, and visitors are at a safe range from the tools and debris.

• Use a vise or clamping device to hold work piece firmly in place.

• Do not apply excessive force on tool or apply "rough" treatment to it.

• Always work with a firm footing, posture and proper lighting.

Report to your supervisor any condition of the tool, accessories, or operation you consider unsafe.

Regulator

Filter

• Dynabrade Air Power Tools are designed to

operate at 90 PSIG (6.2 Bar/620 kPa) maximum

air pressure at the tool inlet, when the tool is

running. Use recommended regulator to control

air pressure.

• Ideally the air supply should be free from moisture.

Incorporating a refrigerated air dryer after the

compressor and drain valves at each tool station

(as shown) further reduces moisture from

condensation in the air supply.

OPERATING INSTRUCTIONS

Air System

Lubricator

90 PSIG

(6.2 Bar)

(Sloped in the direction of air flow)

To Tool Station

Drain

Valve

Closed Loop Pipe System

Regulator

Filter

Lubricator

Ball

Valve

Coupler

➤

Drain

Air Hose

Valve

Air Tool

90 PSIG MAX

(6.2 Bar)

LUBRICATOR SETTING

1 DROP/MIN.

20 SCFM

Air Flow

Refrigerated

Plug

Ball

Valve

Air Flow

Air Compressor

and Receiver

Drain

Valve

Air Dryer