Aircraft AITHRE SHIELD EX Series 매뉴얼 - 페이지 5

{카테고리_이름} Aircraft AITHRE SHIELD EX Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aircraft AITHRE SHIELD EX Series 8 페이지. Co and o2 psi sensors for experimental aircraft

페이지 인쇄

Below is an example wiring diagram.

MAKE SURE THE BLACK GROUND WIRE IS GROUNDED TO AIRCRAFT GROUND AS THE PIN

GROUNDS (E.G. PIN 30 AND 28) ON THE GEA 24 MAY NOT ALWAYS BE CONNECTED TO

AIRCRAFT GROUND.

After wiring, set up the Aithre Shield EX detector as a GP (general purpose) input to the engine monitor

and selected Custom Analog as a gauge. Then calibrate the gauge for 0v = 0 PPM and 3.3 v = 225 PPM

and then setup the red, yellow and green ranges with the warning levels recommended in the general

instructions above.

EX 3.0 ONLY