DAYLIFF DG 3500PX 설치 및 운영 매뉴얼 - 페이지 6

{카테고리_이름} DAYLIFF DG 3500PX에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAYLIFF DG 3500PX 12 페이지.

2. CONTROLS

All generators are fitted with the following:-

2 no 3 pin AC outlets, +ve and -ve DC connections. DG950 with one

outlet

Engine on/off switch.

Magnetic circuit breaker electric cutout.

Voltmeter (Not DG950)

3. ELECTRICAL CONECTIONS

If the generator is to be connected for standby power use

ensure a qualified electrician is employed. The generator must

be isolated from the utility power when connected or serious

damage will result to the generator and house power circuits.

WARNING

Ensure the total load does not exceed the generator rating. Maximum power

output must only be used briefly or generator damage will occur.

DC output to be used for charging automotive and solar 12V batteries only.

Ensure correct polarity when connecting cables, i.e. +ve to +ve and -ve to -

ve generator to battery terminals.

Ensure the generator is properly earthed. Consult a qualified electrician if in

doubt.

Always start generator before applying load by switching the

circuit breaker and stop the generator after disconnecting

load. Starting and stopping under load will damage the

WARNING

generator and powered accessories.

CHECK ENGINE OIL. Operating without oil will cause severe engine

damage and invalidate the warranty.

To start ensure ignition 'on', fuel valve 'on' and choke 'on' .Then either pull

starter cord (manual start) or turn key (electric start). For electric start do not

turn the engine on for more that 5 seconds. If it fails to start release the switch

and wait 15 seconds before re-trying. Switch off choke when engine has

started.

Check output voltage is 240V on the voltmeter. If not adjust engine speed. If

the speed setting is correct and the voltage is low then the generator is

overloaded and load must be reduced.

If more than one appliance is connected apply load progressively with

greatest load first.