DAYLIFF DG 6000D 설치 및 운영 매뉴얼 - 페이지 7

{카테고리_이름} DAYLIFF DG 6000D에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAYLIFF DG 6000D 12 페이지. Portable diesel generators
DAYLIFF DG 6000D에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (12 페이지)

페이지 인쇄

DC output to be used for charging automotive and solar 12V batteries only. Ensure

correct polarity when connecting cables, i.e +ve to +ve and -ve to -ve generator to

battery terminals.

Ensure the generator is properly earthed. Consult a qualified electrician if in doubt.

5. GENERATOR OPERATION

Always start generator before applying load by switching the

circuit breaker and stop the generator after disconnecting

load. Starting and stopping under load will damage the

WARNING

generator and powered accessories.

CHECK ENGINE OIL. Operating without oil will cause severe engine damage and

invalidate the warranty.

To start ensure ignition 'ON', fuel valve 'ON' and choke 'ON'. Then either pull starter

cord (manual start) or turn key (electric start). For electric start do not turn the engine

on for more than 5 seconds. If it fails to start release the switch and wait 15 seconds

before re-trying. Switch off choke when engine has started.

Check output voltage is 240V on the voltmeter. If not adjust engine speed. If the speed

setting is correct and the voltage is low then the generator is overloaded and load must

be reduced.

If more than an appliance is connected apply load progressively with greatest load

first.

Close fuel valve whenever generator is not operating.

6. ROUTINE MAINTENANCE

For comprehensive diesel engine operation, see separate engine manual.

ENGINE OIL: Check engine oil every time you use the generator. If low refill it. Change

engine oil after first month or after 20hrs operation and thereafter every 3 months or 100

hours of operation, in both cases whichever is sooner.

FUEL FILTER: Every 3 months check the fuel filter under the fuel cock for debris and

clean. Use a spanner to remove.

AIR CLEANER: Check the air cleaner every time you use it and clean it every 3 months or

after 100 hours operations, whichever is sooner. Clean by blowing away accumulated

dust and soaking in kerosene.