Dynabrade Mini-Raptor Vac 61100 사용자 설명서 - 페이지 8
{카테고리_이름} Dynabrade Mini-Raptor Vac 61100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynabrade Mini-Raptor Vac 61100 14 페이지. Wet/dry vac commercial use 16 u.s. gallon 60.5 liter
페이지 인쇄cleaning operation.
20. Replace tank cover, and apply pressure with thumb
to each latch until it snaps tightly into place. Make
certain all lid latches are clamped securely.
21. Insert machine hose end with locking-nut into inlet
of tank. Turn locking nut to tighten. Do not over-tighten.
22. Attach the extension wands
to the accessory end of the
hose. Twist slightly to tighten
the connection. FIGURE 23.
FIGURE 23
23. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 23.
24. Plug the cord into the wall outlet. Your cleaner is
ready for use. I = ON, O = OFF
NOTE: Many more useful tools are available at your
local dealer or Dynabrade Inc.
FILTER
INSTALLATION
AND CLEANING
DRY PICK UP
OPERATION
NOTE: Never use the vacuum for dry pick up without a
dry use filter installed on the lid cage. Using the vacuum
without a filter will cause dust to discharge from blower
port and cause damage to motor.
INSTALLING AND CLEANING THE CARTRIDGE
FILTER:
WARNING!
ALWAYS DISCONNECT THE
PLUG FROM THE WALL OUTLET
BEFORE REMOVING THE TANK
COVER.
NOTE: If foam sleeve (not standard) is installed on lid
cage, remove before installing the cartridge filter.
25. The cartridge filter can be used for dry pick up and
small quantities of wet pick up. Installation is the same
PROUDLY DESIGNED, ENGINEERED, AND BUILT IN AMERICA SINCE 1969
for both. When picking up large quantities of water
we recommend using a foam sleeve (not standard)
instead of the cartridge filter. When picking up fine dust
or powders a high efficiency filter bag must be used
with the cartridge filter.
NOTE: If cartridge filter has been used for wet pick
up, it must be cleaned and dried before using it for dry
pick up.
upside down position, slide
the cartridge filter down over
the lid cage, pushing until the
filter seals against the cover.
FIGURE 24.
FIGURE 24
top of the cartridge filter.
FIGURE 25
one hand, turn the handle on
the filter retainer clockwise to
tighten, locking the filter into
place. FIGURE 26.
FIGURE 26
cleaning, again hold the
tank cover and turn the filter
retainer counter-clockwise to
loosen and remove.
FIGURE 27
30. Slide the cartridge filter off
the lid cage. FIGURE 28.
FIGURE 28
31. Cleaning: Clean installed
filter by simply tapping or shak-
ing the vacuum unit. To restore
optimum airflow, remove filter,
tap end cap against a hard
surface to loosen debris. Ad-
ditional debris can be removed
FIGURE 29
Dynabrade, Inc. 8989 Sheridan Drive
26. With the tank cover in an
27. Place filter retainer into the
FIGURE 25.
28. Hold the tank cover with
29. To remove the filter for
FIGURE 27.
|
Clarence, New York 14031
|
dynabrade.com
PAGE 8