Hi-Z Antennas Hi-Z 8A-80 매뉴얼 - 페이지 12

{카테고리_이름} Hi-Z Antennas Hi-Z 8A-80에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Z Antennas Hi-Z 8A-80 14 페이지. 160/80 meters 200/100 foot diameter circle, a models have the pre-amp external level1 plus amps, level2 with plus6 amps

페이지 인쇄

The Hi-Z Amplifier PLUS or PLUS6 were designed to provide amplification and matching between the short verticals

and the phase controller in the Hi-Z phased array control systems. This amplifier is used on ALL Hi-Z phased array

products. The amp is located at the base of each short vertical. The connecting wires must be short, in the range or 8-

10 inches long. When dressing or routing the wires between the vertical and ground rod to the Hi-Z Amps, maintain as

much separation between the ground and antenna wires as possible. If these wires are to close it will degrade the

system performance. The Hi-Z Amp MUST be Weatherproofed!!

Please review our application and technical notes to gain ideas for mounting the Hi-Z amplifiers near the base of the

verticals. See:

http://www.hizantennas.com/hiz_verticals.htm

Features:



Relay input (lightning and static protection, when power is off)



Easy connections to the base of the vertical and ground

Terminals to Ground and Vertical

Hi-Z 8A Element Man. 3.0

HIGH PERFORMANCE

HF RECEIVING SYSTEMS & COMPONENTS

Hi-Z Antennas™ Hi-Z Amplifier PLUS

Hi-Z Amplifier PLUS

8125 SW Larch Drive

Culver, OR 97734

Hi-Z Amp RG6 Output

Hi-Z Antennas™

USA