Hi-Z Antennas Shack Switch-2 매뉴얼 - 페이지 7

{카테고리_이름} Hi-Z Antennas Shack Switch-2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Hi-Z Antennas Shack Switch-2 12 페이지. Receiving array controller with an oled display

페이지 인쇄

Hi-Z Receiving Array Shack Switch Using an OLED Display

screen returns to the normal direction readout screen. Check the upper right corner of

the screen where you will see the selected array type if array type is selected.

4.2.

Dir or Angle

The direction readout on the screen can be set for compass directions such

as N,NE,S,and SE etc. or in degrees such a 0, 90,135, or 270 etc. The available

directions or angles will depend on the Hi-Z array's available angles. This controller is

shipped pre-programmed for compass directions and to change it, again a knob

depress and rotate the knob until you see

brings up the current setting and rotating the knob allows you to set Direction or Angle.

After this selection a knob press takes you back to the normal direction readout screen.

4.3.

Set Offset

If you have installed your Hi-Z array off axis of a normal compass heading

such as North, Northeast, 90 Degrees etc. you can offset the controller to match your

offset. To enter this mode push the knob and rotate it until you see

Pressing the knob again you will see "-Value and below it a number. The number is the

value of the offset in degrees. You can adjust this positive by clockwise direction or

negative in the counter clockwise direction. Set in your number of degrees offset and

again push the knob to return to the normal direction readout screen. It is possible to

display the actual array angle due to offset by referring to the "Display Top function

below and setting it to actual position. When using Angle as a main readout the display

will show the actual angle the array is receiving from the same as the display top

function.

4.4.

Enable Aux

The "Enable Aux" function is provided to activate one extra auxiliary switch

(#6) output manually. Again to enable this function, press the Hi-Z knob and rotate it

until the

"Enable

show if the function is enabled or disabled. Rotating the knob allows the user to select

enabled or disabled. Pushing the knob will return to the direction screen. There is a little

Aux" function is displayed. Press the knob again and the display will

Hi-Z Antennas Shack Switch 2 Rev.1 10-13-2019

"Dir or

Angle". Depressing the knob again

"Set

Offset".