DYNACO PAS-4 소유자 매뉴얼 - 페이지 6

{카테고리_이름} DYNACO PAS-4에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO PAS-4 15 페이지. Vacuum tube preamplifier
DYNACO PAS-4에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)

페이지 인쇄

Balance Control

This adjusts the proportion of left and right channel signals going to the preamp's line level amplification

stage (and therefore to the preamp's main outputs). Only the left channel signal will be heard with the

Balance Control turned fully counter-clockwise, and only the right channel signal with full clockwise

rotation. The function of the Balance Control is to compensate for unbalanced left and right channel signal

levels (from phonograph records, for instance) or to compensate for non-symmetrical room acoustics

(from furniture, wall reflections, etc.).

Tape Deck Selection - Recording

The TAPE DUBBING switch determines which signals are sent to the tape decks for recording purposes.

If the TAPE DUBBING switch is set to SOURCE, both tape decks receive the same signal - the one

indicated by the position of the INPUT switch.

A copy of a tape can be made when the TAPE DUBBING switch is set to either '2 to 1' or '1 to 2'. (When

this is done, the signal source selected by the INPUT switch is disconnected from both tape decks.)

When the TAPE DUBBING switch is set to '2 to 1', the output of tape deck #2 goes to the input of tape

deck #1 to be recorded. When the TAPE DUBBING switch is set to "1 to 2", the output of tape deck #1

goes to the input of tape deck #2 to be recorded.

The TAPE MONITOR switch can be used to listen to the "source" tape deck (the original recording) or the

"target" tape deck (the dubbed recording) while tape dubbing is being done. However, if the TAPE

MONITOR switch is set to SOURCE, one can listen to any music signal selected with the INPUT switch

while tape dubbing is in progress.

Note:

Some older tape decks which do not have high impedance input circuitry can present non-linear

loads to a preamp's Tape Outputs even when the tape decks are turned off. This can be a

problem because the Tape Outputs are usually connected to which ever signal source has been

selected by the INPUT switch. This "always present" non-linear load can degrade performance on

most preamps.

With the PAS-4 there is a solution to the use of lower input impedance tape decks. Simply keep the TAPE

DUBBING switch positioned to '1 to 2' or '2 to 1' when the deck is not in use. This disconnects the signal

selected by the INPUT switch from both tape decks, as mentioned previously.

___________________________________________