DYNACO PAT-4 조립 설명서 - 페이지 8

{카테고리_이름} DYNACO PAT-4에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO PAT-4 16 페이지. Power supply
DYNACO PAT-4에 대해서도 마찬가지입니다: 조립 설명서 (20 페이지)

Install the Diodes

Be careful! Diodes have a polarity. Make sure the band on the diode aligns with

the banded end of the silk screen!

Designation

Value

1N4004

D10

1N4004

Here's what the 1N4004 diodes look like (not to scale). The package type is known as a

DO-41. The body is black, with a white stripe:

Be careful! Diodes have a polarity. Make sure the band on the diode aligns with the

banded end of the silk screen!

Designation

Value

TZX6V2C

1N4148

D1-D3 have a glass body. They are packaged in the DO-35 package, a smaller package

than the 1N4004's.

The designator D6 is not used.

The TO-92 package looks like this:

In some cases, the leads may be bent as the picture above shows. In other cases, you may

have to spread the outside leads a bit to make it easier to insert them into the board.

Orient the transistor so its body shape matches the silk-screen outline. Leave the top of

the transistor about ½" off the board! The lead length prevents stress on the body and

keeps the transistor safe from too much heat during the soldering operation.

Marking, type

4004, 400 PIV 1 Amp

4004

Marking, Type

TZX6V2, 6.2 Volt Zener, 0.5 Watt

The number 48 is visible, 75 PIV, 100 mA

Page 8 of 16

Done()