DYNACO PAT-5 조립 설명서 - 페이지 15
{카테고리_이름} DYNACO PAT-5에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO PAT-5 18 페이지. Replacement power supply rev e hardware
페이지 인쇄
Remove the four screws (two in each bracket) that hold the silver colored
power supply mounting brackets to the power supply PCB.
Installing the New Power Supply
Figure 11-Mount new PCB to shield and mounting brackets
Pull the Preamp's AC plug and wait 1 minute before going on.
Mount the new power supply to the zig-zag shield using four 4-40 screws
into the power supply mounting brackets.
Return the zig-zag shield and power supply assembly into the chassis.
Use two of the silver colored 4-40 screws and nuts to fasten the power
supply mounting brackets to the bottom of the chassis.
Use two silver colored 4-40 screws and nuts to fasten the zig-zag shield to
the front panel. It's hard to get your fingers in place to hold the nuts. I like
to hold the nut in place using double sided tape wrapped around the blade of
a flat screw-driver. I then use a second screw-driver to turn the screw.
Use four (2 on each side) ¼" hex head self tapping screws to fasten the back
panel to the chassis bottom. Make sure that the back panel sits just inside
the lip on the bottom of the chassis.
Use two silver colored 4-40 screws and nuts to fasten the zig-zag shield to
the back panel.
Remove the old power supply
Installing the new power supply
Page 15 of 18
Done? ()
Done? ()