Daymak Florence 사용자 설명서 - 페이지 6

{카테고리_이름} Daymak Florence에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Daymak Florence 8 페이지.

5. Maintenance and adjustments

5.1 Do not attempt to open the casing of the battery, motor, or regulator or all warran-

tees will become void. If you experience a problem contact our service department.

5.2 Wheel spokes should be adjusted after 6 months. Handlebar and saddle tubes

should never be on the nuts positioning the handlebar, handlebar vertical tube, bicy-

cle saddle, saddle tube and front wheels is 18NM. The minimum torque on the nuts

on the pedal bearing axle and rear wheel is 30NM.

5.3 If the chain becomes loose or frequently comes off the front cog, you can easily

adjust the chain tension by loosening the rear axle nuts slightly, and adjusting the

tension bolts. Make sure that the chain runs freely and re tighten the axle nuts.

5.4 The brake leavers should lock the wheels when compressed half way between

their open position and touching the handlebars. When the need adjusting use the

following methods:

Front brake: Loosen the nuts the cable clamp, then tension or release the steel cable,

until the gap between the wheel and brake rubber is 1.5 to 2.0 mm.

Rear brake: Loosen the nuts on the cable clamp, then tension or release the steel

cable until you can feel the brake lever's motion is ﬂ uid and does not lock the back

wheel until it is the correct position.

Warning: Braking distances increase on wet or icy roads.

5.5 Regularly lubricate the gears and chain with light oil and the brake bushes (not

the rubber brake shoes) with a little grease.

6. Introduction to Main components/parts

Introduction to Main components/parts

1.front wheel

2. motor

3.pedals

4.battery

5.rear derailleur

6.seat

7.rear basket

8.brake lever

9.front basket