DYNACO SCA-80Q 조립 설명서 - 페이지 4

{카테고리_이름} DYNACO SCA-80Q에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO SCA-80Q 15 페이지. C9 replacement
DYNACO SCA-80Q에 대해서도 마찬가지입니다: 매뉴얼 (12 페이지)

3. pencil type soldering iron of 25 to 50 Watts (no huge honking soldering guns or

blowtorches)

4. wire cutters and strippers

5. Magnifying glass, if you're over 42!

Project Overview

The project consists of the following steps:

1. Building the new power supply circuit board.

2. Labeling some wires, desoldering them, and then removing the old power supply

components.

3. Installing the new power supply, testing its outputs, and re-assembling the amp.

By purchasing, using, or assembling this kit, you have agreed to hold AkitikA, LLC

harmless for any injuries you may receive in its assembly and/or use. To prevent injuries:

 Wear safety glasses when soldering to prevent eye injuries.

 Always unplug the power before working on the amplifier.

 Large capacitors hold lots of energy for a long time. Before you put your hands

into the amplifier:

o Pull the AC plug!

o Wait 1 full minute for the capacitors to discharge!

 Remove jewelry and rings from your hands and wrists, or anything that might

dangle into the amplifier.

 If working in the amplifier, keep one hand in your pocket, especially if you're

near the power supply or power supply wires. This can prevent serious shocks.

 Build with a buddy nearby. If you've ignored all the previous advice, they can

dial 911 or get you to the hospital.

We reserve the right to make design/or component changes at any time without prior

The kit must be assembled with 60/40 Rosin Core solder. The recommended diameter is

0.032 inches. Among many such sources of solder, I have used Radio Shack part number

64-009. It contains 8 oz. of solder, which is much more than you'll need to assemble the

kit.

notification.

Page 4 of 15