DYNACO Stereo 400 설치 매뉴얼 - 페이지 4

{카테고리_이름} DYNACO Stereo 400에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO Stereo 400 12 페이지. Replacement rca jack

3. Installing the new RCA Jacks.

4. Reassembling the amp.

Important Safety Notes

By purchasing, using, or assembling this kit, you have agreed to hold Akitika LLC

harmless for any injuries you may receive in its assembly and/or use. To prevent injuries:

 Wear safety glasses when soldering or clipping wires to prevent eye injuries.

 Always unplug the power before working on the amplifier.

 Large capacitors hold lots of energy for a long time. Before you put your hands

into the amplifier:

o Pull the AC plug!

o Wait 2 full minutes for the capacitors to discharge!

 Remove jewelry and rings from your hands and wrists, or anything that might

dangle into the amplifier.

 If working on the equipment with the power on, keep one hand in your pocket,

especially if you're near the power supply or power supply wires. This can

prevent serious shocks.

 Build with a buddy nearby. If you've ignored all the previous advice, they can

dial 911 or get you to the hospital.

 Read and understand the safety manuals of all the tools you use.

We reserve the right to make design/or component changes at any time without prior

The kit must be assembled with 63/37 Rosin Core solder. The recommended diameter is

0.031 inches.

With the exception of fuses, Akitika LLC will replace for free any parts of a correctly

assembled product that fails within one year of the date of purchase when the equipment

has been used in home stereo applications. It is the responsibility of the kit builder to

install the replacement part(s). This warranty applies to the original purchaser only. It

does not apply to units that have been physically or electrically abused, modified without

prior factory authorization, or assembled with other than 63/37 Rosin Core solder.

Akitika LLC's liability shall in no event exceed the cost paid to Akitika LLC for the kit.

notification.

Page 4 of 12