DYNACO Stereo 410 설치 매뉴얼 - 페이지 12

{카테고리_이름} DYNACO Stereo 410에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO Stereo 410 12 페이지. Replacement rca jack

You'll note that the tops of the new RCA jacks project further than the old ones by about

1/8". This may allow the use of a wider range of RCA jack style for making input

connections.

Section 6: Reassembling the ST400

Reverse the procedure used to disassemble the ST400 to reassemble it. Briefly:

1. Carefully wiggle the heatsink assembly back into position in the chassis. Be

careful not to bend components as you work it back into place. Depending upon

your preferences:

a. You may find that it's easier to set the amp on its feet so that gravity could

help guide the heat sinks assembly back into place. Then insert the 4 side

screws in place before turning the amp vertical again to re-install the 9

bottom screws.

b. Alternatively, you may find it easier to leave the amp vertical with its

transformer side down, and re-install the 9 bottom screws, then set the

amp horizontal to reinstall the four side screws.

2. Reinstall the screws that hold the transformer shield to the heatsink.

3. Reinstall the perforated black cover.

4. Return your ST400 to service in your system.

Page 12 of 12