DYNACO Stereo 416 설치 매뉴얼 - 페이지 11
{카테고리_이름} DYNACO Stereo 416에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO Stereo 416 12 페이지. Replacement rca jack
페이지 인쇄Figure 10-solder wires to the new RCA jack assembly
Figure 11-Position the jack assembly prior to installation
Use the supplied 6-32x5/8" sems screw and 6-32 keps nuts to fasten the new RCA jack
assembly to the heatsink. There will be a little bit of play between the mounting holes,
screws, and RCA jack PCB. Your goal is to end up with the RCA jacks centered in their
holes in the heatsink.
In both original and improved forms, the RCA jack grounds should not contact the
heatsink. That isolation prevents the formation of ground loops which could cause hum.
Page 11 of 12