DYNACO DYNALOGIX II DY 4000 전기 매뉴얼 - 페이지 11

{카테고리_이름} DYNACO DYNALOGIX II DY 4000에 대한 전기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO DYNALOGIX II DY 4000 14 페이지.

DY 4000

Inputs

5.0

Inputs

The Dynalogix ll has nine inputs. Inputs are signals coming to the Dynalogix ll

that gets interpreted to create a certain response. For example; a pull cord is

wired to terminal 2 on the Dynalogix ll, when you pullthe cord, it sends a signal

to the Dynalogix ll. The Dynalogix ll knows what the signal is do to the

assigned input (terminal 2) the signal is coming through on. Therefore it will

make the door go up or down. All the inputs have indicator lights and

identification. See Figure: 5.0-1.

Nine inputs with

identification

and indicator

Lights

F ig u re 5 .0 - 1 : Nin e in pu t s on Dynalogix ll

Input 2: Typcally used for activations such as: pullcords, push buttons, photo

eye contacts etc... This input works with the MC/PB timer and can be

put in either manual or automatic operation. Refer to section: 4.1

lnput 3: Typically used for activations such as: floor loops, motion sensors

and any other activations that need to be solely automatic

operations. This input works with the AC/LOOP timer. Refer to

section: 4.2

Input 4: Used for reversing edge either pneumatic (M2lM3) or Wireless

Dynaco Detector (SC+; This input works with the AC/LOOP

timer. Refer to section: 4.2

Input 5: Used for photo eye contact. This input works with the MC/PB timer

and can be put in either manual or automatic operation. Refer to

section 4.1

Input 6: Used to identify a drive error on the Variable Frequency Drive.

Note: lf error light is on, check the VFD for the error code. Refer to

appendix nia for error charts.

t O nur-r-conoree

a f) uonoHn-ooi

l Q neveoce

s Q nxoro

e Q onrveenaon

z Q onrnee

a Q cr-ose ee

e (J

E.STOP/RESET

loLl

tN 1

1 0

DYNACO USA. INC.

7k.Aeado, taDao't Sdkt? &Dutqa