GREAT PLAINS QM Series 소유자 매뉴얼 - 페이지 2
{카테고리_이름} GREAT PLAINS QM Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLAINS QM Series 16 페이지. Positive displacement fuel meter
페이지 인쇄GENERAL INFORMATION
The purpose of this manual is to
assist you in installing, operating and
maintaining your mechanical fuel meter�
Please take a few moments to read
these instructions before installing and
operating your fuel meter�
SAFETY INSTRUCTIONS
The following safety alert symbols are
used in this manual�
DANGER
DANGER indicates a hazardous
situation which, if not avoided, will
result in death or serious injury.
WARNING
WARNING indicates a hazardous
situation which, if not avoided, could
result in death or serious injury.
CAUTION
CAUTION indicates a hazardous
situation which, if not avoided, may
result in minor or moderate injury.
It is your responsibility to:
• Know and follow applicable na-
tional, state and local safety codes
pertaining to installing and operat-
ing equipment for use with flam-
mable liquids�
• Know and follow all safety precau-
tions when handling petroleum
fuels
• Ensure that all equipment operators
have access to adequate instruc-
tions concerning safe operation and
maintenance�
2
1. Appropriate Use of QM Meter:
a� The UL Approved version of
this meter is for use only with
thin viscosity petroleum fuels
such as gasoline, gasoline-
ethanol blends (E15 maximum),
diesel and kerosene�
b� The non-UL Approved version
of this meter is for use only with
diesel fuel and kerosene�
DANGER
2�
tions against fire or explosion when
dispensing fuel� Do not operate the
meter in the presence of any source
of ignition including running or hot
engines, lighted cigarettes, or gas
or electric heaters�
WARNING
3�
such as hose, nozzle, or pump
added to your meter must be stati-
cally grounded and approved for
use with petroleum fuels�
WARNING
4�
skin contact with petroleum fuels�
Use protective goggles, gloves,
and aprons in case of accidental
splashing or spillage� Change
saturated clothing and wash skin
contact areas promptly with soap
and water�
This meter is designed for the field
measurement of thin viscosity
petroleum fuels only and intended for
use with pump systems up to 40 GPM
(150 LPM) flow range (not intended for
gravity flow systems)� Using mechanical
gears, these meters translate flow data
from positive displacement oval gears
into calibrated units which are indicated
on the face of the meter� This meter is
factory calibrated for diesel fuel� Field
calibration feature is available for other
fluids, see Calibration section�
Observe precau-
Any components
Avoid prolonged