DynaColor 960H H.264 DVR 설정 매뉴얼 - 페이지 5

{카테고리_이름} DynaColor 960H H.264 DVR에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DynaColor 960H H.264 DVR 12 페이지.

Basic Setup

Enter the OSD main menu and setup some basic configuration of the DVR. The basic configuration

can be set via either the DVR or DVRRemote, the remote software.

Enter OSD Main Menu:

 Click on the MENU icon to enter the OSD main menu.

 Select the administrator account "admin" to login. Enter the preset password "1234".

 It is strongly suggested to change the password to prevent unauthorized access.

Date / Time Setting:

Follow steps below to setup date / time before the recording starts. Refer to the User's Manual for

advanced setup of Time Sync function.

 Select <Date/Time> in System menu.

 Select the date and time, and adjust the value by clicking on UP / DOWN buttons.

 The new date and time settings take effect after the changes are confirmed.

Language Setting:

If users wish to change language of the DVR system, follow the steps below.

 Select <Language> in System menu.

 Click on the Down button to choose the preferred language.

Configure the LAN setup for the DVR to properly function with Ethernet connection. The default IP

of the 960H H.264 DVR must be changed to avoid network conflicts.

 From OSD main menu, select <System>  <Network Setup>, set the <LAN Select> item to

<LAN> or <PPPoE> according to the network application, and enter <LAN Setup>.

 For DHCP users, set the DHCP to <ON>. The IP address, Netmask, Gateway and DNS settings

are retrieved from network servers. DHCP is dynamic that the settings change from time to time.

 For Non-DHCP users, set the DHCP to <OFF>. IP address, Netmask, Gateway and DNS

settings must be set. Please obtain the information from the network service provider.

 To change the IP address, Netmask, Gateway and DNS value, click on the <Num> button to

display the number pad and input users' preferred setting values.

 PPPoE users must set the <PPPoE Account> and <PPPoE Password> as well.

 When the settings are complete, click on the item again to confirm and save the settings. Right

click or click on <X> in the upper right-corner of the window to abort.