ADEMCO LYNXR Series 빠른 시작 매뉴얼 - 페이지 7

{카테고리_이름} ADEMCO LYNXR Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ADEMCO LYNXR Series 8 페이지.

Remote Phone Control Operation

To remotely disarm system:

To remotely arm in AWAY mode:

To remotely arm in STAY mode:

To remotely arm in AWAY or STAY with NO DELAY:

To remotely activate X-10 devices 1-6: [#] + [4] + device no.

To remotely activate X-10 devices 7 & 8:

To remotely deactivate X-10 devices 1-6: [#] + [7] + device no.

To remotely deactivate X-10 devices 7 & 8:

To remotely bypass a zone:

To remotely activate forced bypass:

Note: Force bypass option must be enabled.

To remotely check system status: [*]

To end remote phone session: Hang up or

Speaker Phone Operation (LYNXR-EN Only)

(Note: The ARMED and READY LEDs blink alternately when the Speaker Phone feature is active)

To place a call or answer a call using the speaker phone: [#] + AUX

To Flash (switch between two calls using call waiting): AUX

To hang up and exit speaker phone mode: OFF

To enable/disable (toggle) ringer: [#] + VOLUME + AUX

To return the keypad to telephone mode after disarming the system: [#] + AUX

Note: The Babysitter Code and Installer Code cannot disarm the system unless it was the code used to arm the system. In

addition, if the system is armed by pressing and holding the Quick-Arm buttons, neither the Babysitter Code nor the

Installer Code can disarm the system.

REFER TO THE INSTALLATION AND SETUP GUIDE FOR THE LIMITATIONS OF THIS SYSTEM AND

WARRANTY INFORMATION.

+ [1]

+ [2]

+ [3]

+ [#] + [4] + device no.

+ [#] + [7] + device no.

+ [6] + zone no.

+ [6] + [#]

+ [9]

-7-

+ [2] or [3] + [0]