Aircraft In Miniature HW72-03-001 역사, 참고 사항 및 조립 지침 - 페이지 7
{카테고리_이름} Aircraft In Miniature HW72-03-001에 대한 역사, 참고 사항 및 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aircraft In Miniature HW72-03-001 9 페이지. 1:72 metal kit of the 1909 santos dumont demoiselle
페이지 인쇄D Fold the small lugs on the control column through 90°, then attach it to the right lower
longeron of the fuselage structure.
E Attach the fuel pipe (an etched nickel silver part) to the underside of the fuel tank
and to the rear of the engine
F Attach the engine to the front of the fuselage structure
G Attach the propeller to the engine.
6 AIRFRAME COVERING AND PAINTING
A If the airframe is to be painted, do it at this stage in the assembly. Paint the structure
to resemble a light to medium brown wood. If the model is to be covered with
Litespan film, do not paint those areas where adhesive will be applied.
B If the model is to be covered with Litespan film (the film), cover the fuselage and
flying surfaces now. For each area:
(1)
Cut a piece of the film which is larger than the panel.
(2)
Apply a continuous layer of cyanoacrylate adhesive (superglue) to the
structures where the film will be attached.
(3)
Attach the edge of the piece of film to one long edge of the bay and press it
down so that it is smooth, and without creases.
(4)
When the superglue has attached the film securely, apply more superglue
to the other three sides of that bay.
(5)
Pull the film smooth and attach the other three sides of the panel of film, so
that it is smooth and not slack.
(6)
When the film is securely attached, use a sharp blade to trim off the
excess film.
(7)
Do this procedure again for all the other panels to be covered.
7 RIGGING
A Add rigging if desired as shown in the 3 view drawing. We have found black
monofilament to give good results.