HiB Globe 60 매뉴얼

Quality Bathroom Products

60cm

zone

2

zone

zone

2

1

This product is suitable for installation in zones:

All installations must comply with guidelines which are based on a zonal concept. The

diagram above illustrates this concept and must be followed to ensure the safe installation

of electrical appliances in the bathroom. These regulations apply to domestic installations

only. Installations must be made in accordance with the current IEE wiring regulations and

relevant building regulations. HiB recommends that all electrical bathroom products

should only be fitted by a suitably qualified, Part P registered electrician.

Mounting Points Diagram

REAR VIEW

mounting points

NB. This product must be installed with a minimum distance of 150mm

between the infra-red sensor switch and any adjacent wall or object to

ensure correct operation of the sensor.

Wiring Diagram

Live is Brown

Earth is Green and Yellow

Neutral is Blue

LUMINAIRE

+44 (0)20 8441 0352

HiB Ltd. Building 3, North London Business Park, Oakleigh Road South, New Southgate, London. N11 1GN

©HiB Copyright: No part of this document may be reprinted or duplicated without HiB consent. All sizes and measurements are approximate, but we do try and make sure they are as accurate as possible. In the interest

of continuous product development, HiB reserves the right to alter specifications as necessary. E & OE.

60cm

60cm

zone

2

outside

zone

zone

2

60cm

zone

radius

2

zone

1

Hanging landscape

Wiring Diagram

live

Live supply can be Red or Brown

earth

Earth supply is Green and Yellow

neutral

Neutral supply can be Blue or Black

MAINS SUPPLY

+44 (0)20 8441 0219

Globe 45 Art No.78400000 /

60cm

Globe 50 Art No.78500000/

Globe 60 Art No.78600000

Thank you for purchasing this HiB product.

Please read through these instructions carefully and refer back to them

during installation to ensure that your product is fitted safely and that it

zone

2

retains its high quality finish.

Please retain this leaflet for future reference.

Before drilling, ensure there are no hidden cables or pipes in the wall.

Installation

1. Position the mirror in a suitable location (according to the zonal

diagram opposite), ensuring that the domestic electrical mains

supply is within reach of the electrical entry point of the product.

2

2. Carefully mark the position of the mirror using a soft pencil ensuring

it is level. Remove the mirror and mark the mounting points. Please

ensure that all marked mounting points accurately match up with

the fixing points on the mirror.

3. Using a suitable drill bit, drill holes in the marked positions to a

suitable depth. If drilling through tile, use a ceramic drill bit.

4. Insert wall plugs level with the surface of the wall. If fitting to a

tiled surface, wall plugs should be inserted below the tile surface to

avoid cracking. NB. For plasterboard walls, specialist fixings should be

purchased, available from any DIY or hardware store.

5. Screw supplied brackets into wall plugs.

6. Ensure the domestic electrical mains supply to which the mirror is

being connected is turned off. Connect the domestic mains supply

to the terminal box according to the wiring diagram opposite.

7. Hang the mirror in position ensuring that the brackets slot into the

mounting points.

8. Switch the domestic electrical mains supply for the mirror back on.

Operation Instructions

To turn illumination on or off, operate the sensor switch located at the

bottom of the mirror.

Heated Pad is only on when mirror is illuminated.

Care Instructions

Do not use abrasives or solvents when cleaning this product.

Wipe off all water spillages as soon as possible using a soft, damp cloth.

Aftercare Service

In the unlikely event that this product should fail please contact HiB

customer services, contact detail shown below.

WEEE compliance

Must not be mixed with general household waste

Ver No. 1.0 Sept 2014

hib.co.uk