HiB Novum N18DU60MWH 피팅 지침 매뉴얼 - 페이지 5

{카테고리_이름} HiB Novum N18DU60MWH에 대한 피팅 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HiB Novum N18DU60MWH 8 페이지. Blend drawer unit

Installation

Please ensure that the wall is suitable for wall hung furniture. For stud wall

installations, add an extra timber support into the stud wall prior to finishing

1. HiB recommends removing the drawer(s) prior to installation. See Fig. 4,

overleaf.

2. Plan the unit position on the wall, ensuring there is sufficient space between the

unit and other items of furniture in the room.

3. Measure the spacing on the back of the unit, between the two inner sides of the

carcass (Fig. 1, A) this is the maximum bracket spacing. Determine the required

mounting point height.

4. Transfer measurements onto wall using a spirit level to ensure that they are

straight and level, and spaced correctly as per Fig. 1.

5. Drill holes for wall brackets and fix into position with suitable fixings.

6. Position the unit(s) onto the wall brackets.

7. Use furniture hangers to adjust alignment of furniture unit(s) (Fig. 6, screw B,

overleaf), ensuring that they are level.

8. If installing multiple units side by side, once they are both in the correct

position, clamp them together using speed clamps and fix together using the

fixings provided, as per Fig. 2.

9. Once the unit(s) are in position, adjust the screw on the furniture hanger (Fig. 6,

Screw A, overleaf) to bring the furniture tightly against the wall.

10. Refit the drawers.

11. Silicone along back edge of the drawer unit where the drawer meets the wall,

as per Fig. 3. Allow to set fully before use.

the wall to improve strength.

hib.co.uk