GREAT PLANES Big Stir 40 사용 설명서 - 페이지 11

{카테고리_이름} GREAT PLANES Big Stir 40에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Big Stir 40 20 페이지.

❏

5. Position the engine on the engine mount. Adjust the

mount as needed for your engine. Position the engine 4-1/4"

(106mm) from the front of the thrust washer to the firewall.

❏

6. Use a #36 (2.8mm) drill bit and drill the four mounting

holes for the engine into the engine mount. After the holes

have been drilled, tap them with a 6-32 tap. The Great

Planes Dead Center

™

Locator works really well for this task.

PROP AND SPINNER INSTALLATION

❏

1. Install the back plate, prop and prop washer onto the

engine crankshaft. Tighten the nut to hold everything in place.

❏

2. Screw the spinner onto the backplate.

❏

1. Locate the aluminum landing gear. Make a line 1/2"

(13mm) from the leading and trailing edge of the center portion

of the landing gear. Make four marks 3/4" (19mm) from the

bend of the gear. Where the lines intersect is the point where

you are going to drill the hole for the mounting bolts.

(GPMR8130) Engine Mount Hole

❏

2. Drill four 5/32" (4mm) holes in the landing gear on the

four marks you just made.

❏

3. Locate the aluminum landing gear under the plywood

landing gear plate. Center the landing gear over the

plywood plate. Then, using the landing gear as a template,

drill a 5/32" (4mm) hole through the fuselage in each of the

four holes in the landing gear.