HiB Vapor 80 매뉴얼

{카테고리_이름} HiB Vapor 80에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HiB Vapor 80 4 페이지. Cabinet

Vapor 50, 60 & 80 Cabinet

Vapor 50

Thank you for purchasing this HiB product.

Please read through these instructions carefully and refer back to them during installation to ensure that

your product is ﬁtted safely and that it retains its high quality ﬁnish.

Please retain this leaﬂet for future reference.

Before drilling, ensure there are no hidden cables or pipes in the wall. Ensure the domestic electrical

mains supply to which the product is being connected is turned oﬀ for installation.

Please Note

This cabinets is controlled by a PIR sensor with a minimum activation distance of

600mm between the sensor and any solid object/surface with a delayed response time of approximently two

seconds. The cabinet will remain on until the PIR sensor is not obstructed for approximately 5 Minutes.

1)These products must be installed with a minimum distance of 300 mm between the infrared sensor switch and

any surface or object to ensure correct operation of the sensor.

The front edge of the basin should be less than 600 mm when measured from the front of the cabinet.

2)The cabinet is a Class 1 appliance and, as such, must be connected to the earth wire of the household power

supply.

3) USB Socket

If an appliance is connected and the current draw exceeds 1.5A, the USB driver will automatically go into

protective shutdown mode and the LED light on the USB socket will ash.

Disconnecting the appliance will reset the USB driver.

Any appliance that requires more than 1.5A current should not be used in the USB socket.

51400

Vapor 60 & 80

Art No.

51500 & 51600

#02 018 R171116

Ver No.

approximately

1.0 Jan 2018