Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910 조립 지침 매뉴얼 - 페이지 4

{카테고리_이름} Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aircraft in Miniature Limited Historic Wings Bristol Boxkite 1910 10 페이지. 1:72 metal kit

페이지 인쇄

Fret 3

ASSEMBLE THE SPOKED WHEELS

A Drill a 1/16"/1.5mm diameter hole through the centre of the female form tool as

shown in Figure 1 below. This is to let you push the discs of spokes out of the form

tool after they have been formed into a cone.

B Remove the eight spoke discs from the fret and remove any burrs from the

attachment tabs.

C Form each spoke disc.

(1) Put each disc into the cavity in the female form tool.

(2) Put the male form tool into the cavity and press the disc into a cone. Figure 2

shows a vice being used to compress the form tool.

NOTE: These photographs show typical

wheels, spoke discs and tyres.

They are NOT specific to this kit.

(3) Remove the form tool from the vice and remove the formed disc of spokes.

(4) Do steps 1 C (1) thru 1 C (3) again for each of the spoke discs.

WHEEL

SPOKE DISCS

Figure 2

ENGINE PUSH

ROD

(7 needed, 7 spare)

DRILL HOLE IN FORM TOOL HERE

Figure 1