GREAT PLANES EP YAK 55 3D 사용 설명서 - 페이지 7

{카테고리_이름} GREAT PLANES EP YAK 55 3D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES EP YAK 55 3D 16 페이지.

3. Slide the joiner tube through the fuselage bushings.

4. Slide the other control horn/spacer onto the joiner

tube. Do not glue it in place yet.

5. Test fit the other stabilator half onto the joiner rod.

Lengthen the slot in the stabilator half if necessary to allow

it to fit snugly against the spacer.

6. Tip: Use 6-minute epoxy for this step to allow yourself

enough working time. Glue the stabilator half and spacer to

the joiner tube. Use two square sticks (any scrap you have

will do) and lightly clamp the stabilator halves between them

to align everything while the glue hardens.

Assemble the Fin & Rudder

1. Glue two nylon pin hinges into the precut slots in the fin. Be

careful not to get glue into the pivoting section of the hinge.

2. Glue the hinges into the precut slots in the rudder.

3. Glue the fin to the fuselage. Make sure that it is straight

and centered both vertically and longitudinally.