GREAT PLANES EXTRA 330SC 사용 설명서 - 페이지 9

{카테고리_이름} GREAT PLANES EXTRA 330SC에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES EXTRA 330SC 20 페이지. Model aircraft great planes extra 330sc

Note: The crutches are no longer needed, but the

top crutches provide a good stand while installing the

radio system.

❏

23. Turn the plane upside down and glue the two

horizontal fuselage doublers to the front of the fuselage.

Make sure they are ﬂ ush with the front of the fuselage and

against the vertical fuselage.

❏

24. Glue the two vertical fuselage doublers to the front

of the fuselage. Make sure they are ﬂ ush with the front of the

fuselage and against the horizontal fuselage doublers.

❏

25. Glue the motor mount to the front of the fuselage.

Apply a bead of glue to the joint on all sides of the fuselage

and motor mount.

RADIO INSTALLATION

❏

1. Connect the rudder servo to your receiver. Remove the

servo screw from the servo and install a large servo arm onto

the servo. Center the trims on the transmitter. Position the

servo arm so that one arm is perpendicular to the centerline

of the servo. Use diagonal pliers to remove the three extra

servo arms.

❏

2. Install the rudder servo by placing it into the aft servo

mount location with the output shaft towards the front of the

fuselage. Glue the servo in place with foam safe CA. Be

careful to not get any glue inside the servo case.

❏

3. Use foam safe CA to glue the elevator servo offset

around the elevator servo mounting hole.