GREAT PLANES Fling 2m ARF 사용 설명서 - 페이지 9

{카테고리_이름} GREAT PLANES Fling 2m ARF에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Fling 2m ARF 16 페이지.

❏

3. With the servos centered, install a servo arm onto each

servo. Trim the arms as shown.

❏

4. Locate the two 40" [1016 mm] pushrod wires. Put a

Z-bend in one end of each wire as shown. Z-bend pliers

work best for this.

❏

5. Insert each wire into the pushrod guide tubes in

the fuselage.

❏

6. Remove the servo arms and insert the Z-bend into the

second hole out from center on the arms. Reattach the

servo arms and servo arm screws.

❏

7. Position a white nylon control horn in line with the

rudder pushrod exiting the fuselage. The control horn should

be 1/2" [13 mm] from the top of the stab as shown. Ensure

the holes in the control horn line up with the hinge line. Mark

the location of the control horn screws with a felt-tip pen or

pencil. Drill 3/32" [2.4 mm] holes at these marks. Attach the

control horn to the elevator control surface using two of the

supplied #2 x 1/2" [13 mm] machine screws and a white

backplate on the back of the control surface.