GREAT PLANES Fokker D.VII ARF ElectriFly 사용 설명서 - 페이지 13

{카테고리_이름} GREAT PLANES Fokker D.VII ARF ElectriFly에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Fokker D.VII ARF ElectriFly 20 페이지.

Install the Top Wing

❏

1. Study the above drawing carefully. There are four pairs of

strut mounts. They are labeled AC9a, AC9b, AC9c, and AC9d.

Test fit the bottom mounts into their respective strut mount

pockets in the bottom wing. Do not glue them in place.

❏

2. Use 2mm x 7mm [5/64" x 9/32"] self-tapping washer head

screws to hold the end struts in place as shown. The end struts

have "TF" stamped into them to indicate "Top Front."

❏

3. Install and remove four 2mm x 7mm [5/64" x 9/32"] self-

tapping washer head screws into the pre-drilled holes on

each side of the fuselage. Apply a couple of drops of thin CA

into each hole to harden the threads.

❏

4. Locate the two "V" shaped cabanes and screw them in

place with four 2mm x 7mm [5/64" x 9/32"] self-tapping

washer head screws as shown.

❏

5. Locate two straight cabane struts. Secure the top of the

straight cabane strut to the "V" cabane with a 2mm x 6mm

[5/64" x 7/32"] machine screw. Be sure to use a drop of

threadlocker on the screw. Attach the bottom of the strut to

the fuselage with a 2mm x 7mm [5/64" x 9/32"] self-tapping

washer head screw.

❏

6. Attach the top wing to the center cabanes with two

2-56 x 9.5mm [3/8"] machine screws and two 2mm [5/64"]

washers as shown.

❏

7. Put the center rear cabanes in place. Attach the

cabanes with 2mm x 7mm [5/64" x 9/32"] self-tapping

washer head screws at the sides of the fuselage and with

2-56 x 9.5mm [3/8"] machine screws and two 2mm [5/64"]

washers in the bottom of the top wing.