GREAT PLANES Riot 3D 사용 설명서 - 페이지 13

{카테고리_이름} GREAT PLANES Riot 3D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Riot 3D 20 페이지.

페이지 인쇄

❏

3. Temporarily attach a 1" [25mm] main wheel to the

landing gear wire. Align a wheel pant as shown. Mark on the

wheel pant where the landing gear wire enters the pant. Drill

a 1/16" [1.6mm] hole in the wheel pant.

❏

4. Slide the wheel pant onto the landing gear wire along

with a wheel retainer (D6) as shown. Glue the wheel pant

and wheel retainer (D6) in place using medium CA.

❏

5. Attach a main wheel and center it in the wheel pant

opening. Use the included white plastic retainers to hold

the wheel in place. Secure the white plastic retainers with a

drop of medium CA. Be very careful NOT to glue the

wheel to the wire.

❏

6. Final gear installation will resemble the photo above.

ATTACH THE PROPELLER

❏

1. Connect the propeller to the motor as shown using the

rubber O-rings supplied with the motor. Be sure the screws

holding the O-rings are held in place with Threadlocker.

Propeller installation will resemble the inset photo

shown above.

APPLY THE DECALS

1. Use scissors or a sharp hobby knife to cut the decals from

the sheet.

2. Be certain the model is clean and free from oily

fingerprints and dust. Prepare a dishpan or small bucket with

a mixture of liquid dish soap and warm water–about one

teaspoon of soap per gallon of water. Submerse the decal in

the soap and water and peel off the paper backing. Note:

Even though the decals have a "sticky-back" and are not the

water transfer type, submersing them in soap & water allows

accurate positioning and reduces air bubbles underneath.

3. Position the decal on the model where desired. Holding the

decal down, use a paper towel to wipe most of the water away.

4. Use a piece of soft balsa or something similar to

squeegee remaining water from under the decal. Apply the

rest of the decals the same way.

GET THE MODEL READY TO FLY

Check the Control Directions

❏

1. Turn on the transmitter and receiver and center the

trims. If necessary, remove the servo arms from the servos

and reposition them so they are centered. Reinstall the

screws that hold on the servo arms.

❏

2. With the transmitter and receiver still on, check all the

control surfaces to see if they are centered. If necessary, adjust

the clevises on the pushrods to center the control surfaces.