GREAT PLANES Riot 3D 사용 설명서 - 페이지 6

{카테고리_이름} GREAT PLANES Riot 3D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Riot 3D 20 페이지.

ASSEMBLE THE FUSELAGE

❏

1. Locate the pre-hinged horizontal stab and elevator.

Measure and mark the center of the stabilizer as shown.

❏

2. Carefully cut a slot for the elevator control horn in the

area marked on the sketch.

❏

3. Insert the stab into the fuselage. Align the mark with

the centerline of the fuselage.

❏

4. With the model sitting on a flat surface, measure the

distance from each stab tip to the surface. The measurements

A=A

should be equal. Sand the slot in the rear of the fuse as

needed for a proper fit.

❏

5. Using a piece of string, measure the distance from the

center of the nose of the fuselage to each of the stab tips.These

distances must be equal. Mark the stab where it enters the

fuselage. Trim the covering from the stab inside the marks.

❏

6. Glue the stab in place once it is aligned with thin CA.

❏

7. Locate the fin. Glue it in place along the centerline of

the fuselage as shown. The fin must be perfectly straight up

and down and at a 90° angle to the stabilizer.