Days EQUALIZER SYSTEMS AM Series 설치 및 운영 매뉴얼

{카테고리_이름} Days EQUALIZER SYSTEMS AM Series에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Days EQUALIZER SYSTEMS AM Series 7 페이지.

Installation and Operation Guide

AM Series

Single Leg Hydraulic Jack: 12,000# Capacity

Installation

Tools Required for Installation

• Ratchet, sockets and wrench set

• Wire cutters / crimpers

• Electric drill and bits

• Screw gun bit

• Welding equipment (if welding jack in place)

Additional Parts Needed for Installation

• # 4 gauge power wire (to connect battery +12V

• to the Pump)

• # 4 gauge ground wire (to connect battery

• # 4 gauge ring terminals

• Loom clips (to secure switch and harness to the trailer)

• Self tapping screws or pop rivets (to secure loom clips)

• Wire tie

Jack

Your AM Jack may have been provided with a mounting flange or bracket (depending on the

mounting option ordered for your system). When Bolting the Jack to the trailer we recommend using

Grade 8 bolts. Welding the Jack in place requires sound welding practices.

The Jack should be mounted so that when the trailer is level (while mounted to the tow vehicle) there is

10 inches

Minimum

of Ground Clearance. This is usually achieved by mounting the jack so that the

foot is slightly below the bottom edge of trailer. The bottom of the footpad should not be lower than

any other Item mounted on the trailer.

1-800-846-9659

equalizersystems.com

January 2011

Revision- January 2021

-12V Ground

Positive

to Pump)