GREAT PLANES SEAWIND RP RX-R 사용 설명서 - 페이지 9

{카테고리_이름} GREAT PLANES SEAWIND RP RX-R에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES SEAWIND RP RX-R 16 페이지.

페이지 인쇄

(It will probably be necessary to reverse the throttle direction

in the transmitter.) Also make sure the servo arms don't

interfere with the ESC or the mounting strap. If necessary,

cut off the unused servo arms or adjust the position of the

ESC and the strap. You may double-check and set the control

throws now, or wait until you get to the "Set the Control

Throws" section on page 10.

❏

9. Cut off the excess pushrod wire, but leave approximately

1/4" [5mm to 6mm] protruding from the screw-lock pushrod

connectors in case small adjustments will ever be required

later on.

❏

10. Connect the aileron pushrods to the torque rod horns on

the ailerons with the 90° connectors and to the screw-locks in

the servo arm. Center the ailerons and tighten down the screws

in the connectors with a drop of threadlocker on the threads.

Make sure you have the servo arm screw in the servo.

❏

11. Cut off the extra pushrod wire, but leave approximately

1/4" [5mm to 6mm] protruding from the screw-lock

pushrod connectors.

❏

12. Use the transmitter to operate the ailerons to make

sure they respond in the correct direction. You can set the

control throws now, or wait until you get to the "Set the

Control Throws" section on page 10.

❏

13. Use thick or medium foam-safe CA, epoxy, R/C 56 or

waterproof white glue to glue on the wing tips. If necessary,

use pins to hold them in position while the glue is drying.

GET THE MODEL READY TO FLY

Balance the Propeller & Mount the Spinner

❏

1. For optimum performance and motor efﬁ ciency balance

the propeller using a Top Flite

Balancer (TOPQ5700) or other suitable balancer. Use a

hobby knife or sandpaper to sand the one side of the heavier

blade until you can get the prop to balance.

❏

2. Mount the propeller with the included aluminum

propeller washer. Use a few dabs of RTV silicone, R/C 56 or

waterproof white glue to glue on the spinner. Using just a few

dabs of any of the soft glues recommended should allow the

spinner to be removed if ever necessary in the future. If the

spinner becomes damaged two spares are provided.

Precision Magnetic Prop