GREAT PLANES Silhouette 사용 설명서 - 페이지 4

{카테고리_이름} GREAT PLANES Silhouette에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Silhouette 16 페이지.

INSTALL THE WING

Due to the radius of the leading edge of the wing and the material

used in construction of the wing, small cracks are not uncommon

and will not cause any undesirable ﬂ ight characteristics.

❏

1. Remove the battery hatch (canopy top) by carefully sliding

it forward until the tab at the aft end clears the fuselage top.

❏

2. Then lift the battery hatch up and slide it out at the front.

❏

3. Carefully insert the wing in the fuselage so that the

aileron servo openings are on the bottom. Make sure the

string coming out of the center of the wing is inside the

fuselage. If the wing is tight when sliding through the fuselage,

you may have to carefully work it back and forth. If it is still

too tight, lightly sanding the opening may be required. The

reason the wing slides in tightly is that the wing is tapered

and the center of the wing is slightly larger than the section

that is glued to the fuselage. So, do not sand the opening

too much or the wing will ﬁ t loosely in the fuselage, requiring

excessive CA to ﬁ ll the gap.

❏

4. Slide the wing forward and center the wing in the fuselage.

Measure the distance from the wing tips to the center of the

top of the ﬁ n. Adjust the wing so that the distance is the

same. T-pins can be inserted in the trailing edge to help hold

A = A'