GREAT PLANES Slow Poke Sport .40 사용 설명서 - 페이지 9

{카테고리_이름} GREAT PLANES Slow Poke Sport .40에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Slow Poke Sport .40 20 페이지. Arf plane

4. Install the aileron servo into the servo bay using the

hardware supplied by the radio manufacturer. Drill a 1/16"

[1.6mm] pilot hole through each of the servo mounting

holes. This will prevent the hardwood blocks from splitting

when you install the screws.

5. Temporarily plug your aileron servo into the

receiver. Turn the radio system on and allow the servo to

center itself. With the servo centered install a medium length

servo arm onto the servo so that the arm is on the left side

of the servo as shown in the photograph. (The arm will be on

the right side of the servo for the installation of the servo in

the opposite wing.)

6. From the inboard end of the aileron measure in 1"

[25mm]. Draw a line on that mark across the aileron as shown.

Correct

7. Locate one of the nylon control horns. Separate

the horn and the screw mounting plate. (You can discard the

screw mounting plate.) Place the control horn on the aileron,

aligning the center of the horn on the line that you have

drawn. Position the horn at the leading edge of the aileron as

shown in the sketch. Trace the outline of the control horn onto

the aileron and mark the location of the mounting holes.

8. Drill a 1/6" [1.6mm] hole 3/8" [9.5mm] deep on both

of the mounting hole locations. Using a T-pin, poke small

holes through the iron-on covering, piercing the wood under

the covering.

9. IMPORTANT: Do not omit this step! Using thin CA

saturate the small pin holes and the holes you drilled for the

mounting screws. Allow the CA to cure. Install a #2 x 3/8" [#2

x9.5mm] sheet metal screw into each of the mounting holes.

Remove the screw and put a couple of drops of thin CA into

the screw holes and allow the CA to cure.

Incorrect