GREAT PLANES Sport Float Kit ARF 사용 설명서 - 페이지 4

{카테고리_이름} GREAT PLANES Sport Float Kit ARF에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Sport Float Kit ARF 16 페이지.

Parts Identification

Before starting to build, use the Parts Identification list to

take an inventory of this kit to make sure it is complete, and

inspect the parts to make sure they are of acceptable

quality. If any parts are missing or are not of acceptable

quality, or if you need assistance with assembly, contact

Product Support. When reporting defective or missing

parts, use the part names exactly as they are written in the

Kit Contents list on this page.

Great Planes Product Support:

Telephone: (217) 398-8970

Fax: (217) 398-7721

Hardware bag contents:

(3) SMALL NYLON TIE STRAP

(3) FLAT LANDING GEAR STRAPS, TREE OF 4

(34) #4 X 1/2" PHILLIPS HEAD SHEET METAL SCREW

(4) WHEEL COLLAR SET SCREW

(4) 5 mm WHEEL COLLAR

(35) #4 FLAT WASHER

(1) 2-56 HEX NUT

(1) 4-40 LOCK NUT

(4) #62 RUBBER BAND

(1) 2-56 X 3/8" PHILLIPS HEAD SHEET METAL SCREW

(1) 4-40 X 1/4" SOCKET HEAD CAP SCREW

Before starting assembly, assemble the model and mark

the balance point of the model. You will need to know this

later when the model is balanced with the floats installed.

If you are not going to install a servo inside the float, skip the

following section and go to "Assemble the Water Rudder" on

page 6.

(3) 2-56 X 1/2" PHILLIPS HEAD MACHINE SCREW

(1) BRASS BODY FOR SCREW-LOCK CONNECTOR

(1) NYLON RETAINER

(1) FASLINK

(1) RUBBER BOOT

(1) 4-40 x 1/8" SOCKET HEAD CAP SCREW

(1) LARGE NYLON CONTROL HORN

(1) 5/32" GEAR HUMP STRAP, TREE OF 4

(2) NYLON CLEVIS

(2) SILICONE CLEVIS RETAINER

(1) 2-56 X 1" ROD THREADED FULL LENGTH

(1) 2-56 x 6" THREADED ONE END WIRE