GREAT PLANES synapse arf 사용 설명서 - 페이지 9

{카테고리_이름} GREAT PLANES synapse arf에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES synapse arf 12 페이지.

HOW TO CUT HOLES IN FOAM

❏

A. Using a brass or aluminum tube with a diameter of the

size hole you wish to make. Use a rotary tool with a cutoff

wheel to bevel a sharp edge onto one end of the tube. If you

do not have a rotary tool, a hobby knife can also be used to

carve the inside of the tube until the edge is sharp.

❏

B. Press the tube into the foam and twist. The sharp end

will cut a clean hole through the foam without tear out.

❏

14. Use the included hook and loop material to secure the

battery pack in the front of the radio compartment. Test ﬁ t

the canopy hatch onto the plane and conﬁ rm that it ﬁ ts well.

If any of the electric components interfere with the hatch

seating properly, move the components or enlarge the inside

of the compartment or hatch as necessary until it ﬁ ts well.

GET THE MODEL READY TO FLY

❏

1. Turn on the transmitter and receiver and center the trims.

❏

2. With the transmitter and receiver still on, check all the

control surfaces to see if they are centered. If necessary,

adjust the pushrods by the knurled thumb screws in the

screw-lock pushrod connectors, repositioning the pushrods,

and re-tightening the thumb screws.

3-CHANNEL RADIO SETUP

(STANDARD MODE 2)

ELEVONS MOVE UP

❏

3. Make certain that the control surfaces and the throttle

respond in the correct direction as shown in the diagram.

If any of the controls respond in the wrong direction, use

the servo reversing in the transmitter to reverse the servos

connected to those controls. Be certain the control surfaces

have remained centered. Adjust if necessary.

Use a Great Planes AccuThrow (or a ruler) to accurately measure

and set the control throw of each control surface as indicated in

the chart that follows. If your radio does not have dual rates, we

recommend setting the throws at the low rate setting.

RIGHT ELEVON MOVES UP

LEFT ELEVON MOVES DOWN

FULL THROTTLE