GREAT PLANES Wright Flyer 사용 설명서 - 페이지 7

{카테고리_이름} GREAT PLANES Wright Flyer에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Wright Flyer 16 페이지. Almost ready to fly electric powered r/c airplane

페이지 인쇄

6. Cut the holes for the servos into the bottom wing. Use

the fuselage frame as a guide. The photos above show the

top and bottom of the wing.

7. Cut slots for mounting the receiver box, if you will be

using it. These holes can be seen to the right of the servo

holes in the top photo. (See page 11, step 1.)

Note: If your receiver is too large for the receiver box, use

double-sided tape to hold the receiver in place.

Install the Top Wing

In the following steps the top wing will be installed with six

struts that hold the two wings in position. There are three

types of struts; one with a motor attached, one with notches

in the rear end and one with no notches. In addition, the top

and bottom of each strut has a curved airfoil shape. The

more curved end of this airfoil faces the front of the model.

It is important that these struts are installed correctly in the

following steps.

1. Install the struts in the bottom wing as shown in the

photo above. Notice that the motors on the inner struts face

the inside of the model. The outer struts have a notch in the

rear edge at the top and bottom of the strut. This notch is

used to attach a string in a later step. This notch can be

seen in the photo for step 3.

2. Before completing this step refer to steps 3, 4 and 5 to

be sure that the struts are installed correctly and that the

notches in the outer struts are aligned so that the strings

will align with the posts on the fuselage. Once you are

certain the struts are installed correctly, use a white plastic

strut clip to hold the ends of the struts to the wing. Two clips

are required for each strut.

Note: The clips can be hard to install. Hold the strut carefully

with one hand while pressing the clip onto the end of the

strut with the other hand. Use the tips of two fingers near the

center of the clip and push the clip while rocking it into

place. Do not use a tool. If you slip you could poke a hole in

the wing.